Nurprime SB
Solvent Based Bitumen Coat
Nurprime is solvent based black bitumen paint. When dry the product forms an odorless and taints free bitumen film suitable for the protection of metals, concrete roofing, felt, fiber cement, corrugated iron, asphalt and wood against water attack.
Uses of Nurprime SB
Nurprime provides an effective water proof, weather proof, corrosion resistant protective coatings. It is resistant to low concentrations of alkalis and acids and withstands prolonged oxidation it is suitable for application to a wide variety of materials including iron and steel, lead, zinc aluminum, asbestos-cement, concrete, stone, wood, felt and brick and is mainly used for metal protection, protecting drinking water tanks as a protective coating for concrete structures, stone, bricks, concrete screeds and sand/cement surfaces over coating felt/woo.
Typical Technical Data
| Water Content, % | Max 0.5 | ASTM D95 |
|---|---|---|
| Saybolt Furol Viscosity at 25ºC, Seconds | 25-125 | ASTM D88 |
| Specific gravity at 25ºC | Min 0.85 | ASTM D70 |
| Tests on residue from distillation Penetration at 25ºC, dmm Solubility in Trichlorethylene, % |
20-50 Min 99 |
ASTM D5 ASTM D2042 |
| Distillation, volume % of the
primer Upto 225ºC Upto 360ºC |
Min 30 Min 60 |
ASTM D402 ASTM D402 |
Application
Nurprime is ready for use and should not be thinned. Apply by brush or spray, A minimum of two coats of bitumen paint should be applied, the first should be allowed dry (Normally 2- 4 hours depending on weather condition) before the second is applied application rate 4-6m2 /Liter however the coverage will depend on the porosity of the Substrate. Drying time is 3-4 hours at normal atmospheric temperature. Keep away from sources of ignition. Can be stored atmospheric temperature.
Features
Cleaning
can be removed from equipment and tools with any suitable
solvents such as kerosene or Gasoline or Diesel.
Storage
Up to 6 months in tightly sealed, undamaged container. It
should be stored indoors under
conditions applying to products with flash point of 38 degree Celsius.
Skin Coat
The solvent may have a narcotic effect if inhaled or absorbed
through the skin. Wear
protective clothing and goggles storage.
Coverage
Approximate rate: 0.2 – 0.3 kg/m2. The exact rate will depend
upon the porosity or smoothness of the surface.
Health & Safety
Flashpoint for the product is 38 degree Celsius, so it’s a
flammable material, in
case of fire use dry powder, Carbon Dioxide (CO2) foam. Do not smoke. Wipe
off spillages immediately.
Remarks
Empty cans should be disposed as per the rules and regulations
of the country where
the material is used. And in NO case should empty cans be used for food
stuffing.
Standard: Nurprime complies with drying time of water retention ASTM D41.
Packing: 200Liter Barrel, 20Liter Pails
Advantages
- Single component
- Quick drying
- High Coverage rate
- Excellent water retention for use as a curing compound
- Excellent adhesion to most common building substances
